Progressive-international-electronics Omega2 Manuel d'utilisateur télécharger pdf (Page 9)

OMEGA2/OMEGA Lite Universal Site Interface Installation Guide

Version 1.0 October 2011

Page 5

Connecting to the OMEGA2

POS Connection

Referring to the OMEGA2 Diagram – Front View, which follows, connect to the POS

Port.

• If connecting to a standard PC – Use a standard NULL-MODEM cable.

• If connecting to a VeriFone POS system – Referring to the VeriFone RS232

Adaptor Diagram, which follows, use an RJ45 to DB9 (male) adaptor to

connect to the VeriFone cable.

• If connecting to other non-PC POS systems – Referring to the RS232 to OMEGA

Diagram, which follows, connect using the specified connector pin-outs.

Dispenser Connection

Referring to the OMEGA2 Diagram – Top View, on the next page, locate the

appropriate DBox boards inside the OMEGA2. The position closest to the center of the

OMEGA2 is Channel 1, the next position is Channel 2, the next is Channel 3, and the

last position is the Reader Board. When shipped, the OMEGA2 is only equipped with

the DBox board(s) and/or Reader Board specified for the order. Since the OMEGA2

can accommodate mixed brands, refer to the brand-specific board and the

corresponding wiring diagram for that board, which follows later in this manual. See

Start-Up and Configuration in the next section of this manual for information on

logging in to the OMEGA2 web site to configure the dispensers.

ATG & Price Signs

Referring to the RS232 to Omega Diagram, which follows, create a cable to these

specifications. Referring to the OMEGA2 Diagram – Front View, on the next page,

connect to the Auxiliary Connections Port(s). See Start-Up and Configuration in the

next section of this manual for information on logging in to the OMEGA2 web site to

configure the ATG and/or price signs.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Progressive-international-electronics Omega2 Manuel d'utilisateur Page 9