Progressive-international-electronics PIcon Console Manuel d'utilisateur télécharger pdf (Page 23)

PIcon Program & Report

Rev 2.0 June 2006

Page 19

Mode Descriptions

The sequence for manager access must be completed before programming features can be

utilized through the various program modes. The sequence for either manager access or operator

access allows generation of reports (Modes 10 and 11). Each set of instructions for the following

program and report modes assumes that the appropriate manager/operator access has already

been executed and that the mode number (M 0) prompt now appears in the display. To operate

the PIcon, Modes 1 and 2 (at least) must be programmed.

Mode 1 — Dispenser Setup Information (Manager only)

In Mode 1, hose selection, product, service, blend and slowdown amount are entered for each

dispenser/fueling position controlled by the PIcon. After being prompted for mode number

(M 0), press <1> on the numeric keypad and then press <ENTER>. You are now in Mode 1.

To initiate dispenser programming, press the <PUMP #__> key for the first dispenser/fueling

position at the site (usually Dispenser #1).

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 36 37

Pas de commentaire

Progressive-international-electronics PIcon Console Manuel d'utilisateur Page 23